HG Hagesan Super Protector For Wall and Floor Grout HG346

Directions for use: The grouts should be clean and dry prior to treatment. For this reason, first clean the grouts thoroughly, using HG Grout Cleaner for bathroom grout clean with HG Hagesan Blue. After cleaning, rinse all joints well with clean water and allow 24 hours for the area to dry. Sufficient time should be allowed for new grouts to dry and to harden completely. Floor grout in bathrooms, kitchens and, also, intensively used floors (entrances / halls) etc.: Apply HG Super Protector using the supplied pipette. Use 1-2 ml of liquid per running metre of the joint (of 0.5cm width). Wall grout in bathrooms and kitchens etc.: Apply the HG Super Protector to the joints, using a small brush and allow to dry for 1 hour. Then the treatment should be repeated, so obtaining optimal protection. The product must penetrate into the joint within 5 minutes. Remove any surplus using a clean cloth. After 36 to 48 hours, the treated surface can be cleaned in the normal manner. For floor joints, the floor can be used after approx. 3 hours. Floors in showers can be used after approximately 8 hours. Coverage: 250 ml per 30-40 m² of tiled surface area (based on tiles measuring 30 x 30 cm, and a grout width of 0.5 cm). Attention: Please always follow the instructions. HG Super Protector is a transparent fluid that may colour the joints a little lighter or darker , depending on the composition of the joint mortar. When in doubt, we recommend that you first try the product on a location out of sight. Do not use too much as fluid may colour the joints yellow. Tip: When applying by brush, choose a brush of similar width to the grout joints.